Crossover to PSA, resubmitting, and reholdering an old slab
You have a graded Pokémon card and the number on the label feels low. The card looks clean, and the idea arrives: crack it out, send it back, get the grade it deserves. Sometimes that's the right call. More often the first grade was right, and the card comes back the same, or lower, after weeks away and a second fee. This guide covers when cracking makes sense, when a crossover means you don't need to crack at all, and how to get a card out of its case safely if you do.
What cracking a slab means, and when you don't have to
To crack a slab is to break open the sealed case and take the card out. Collectors do it for two reasons:
- Resubmitting to the same company, hoping for a higher grade.
- Crossing over to a different company, usually because that label is the one buyers want for the card.
The moment the case is open, the card is raw again. It has lost the protection of the holder and the grader's guarantee that it's genuine, and it has to be packed, shipped and graded from scratch.
Crossover to PSA without cracking: how the minimum grade works
If you are moving a CGC or BGS card to PSA, check the crossover route before you reach for the pliers. On PSA's crossover service, PSA grades the card while it's still inside its current holder. You set a minimum grade on the form, and PSA only removes the card and slabs it if it meets that grade. If it doesn't, the card comes back in its original case. PSA notes the grading fee applies whatever the result, and it has since announced lower crossover pricing when a card doesn't cross at some service levels.
That removes the worst outcome of cracking: ending up with a raw card and a lower grade than the one you started with. A crossover with a minimum grade at your current grade can only keep the card where it is or move it up.
How often does a Pokémon card get a PSA 10?
Whether a higher grade is realistic depends on the card. The gem rate is the share of all PSA-graded copies that received a 10, and it varies enormously between vintage and modern cards.
| Card | PSA 10 population | Gem rate |
|---|---|---|
| Base Set Charizard | 488 | 0.5% |
| Fossil Dragonite | 60 | 0.3% |
| Crown Zenith Giratina VSTAR | 24,964 | 54% |
| Evolving Skies Umbreon VMAX | 22,108 | 69% |
On a vintage holo like the Fossil Dragonite, very few copies have ever been graded a 10. If yours came back a grade lower, the grader most likely saw the same flaw a second grader would: a soft corner, a print line, off-centre borders. Resubmitting a vintage card on hope rarely changes the number.
Modern alt arts like the Crown Zenith Giratina VSTAR are the opposite: a large share of graded copies are 10s. That makes a resubmission more plausible, but it also means a 10 is common, so the higher grade changes less about the card. Our guide to what a PSA 10 means explains what separates the top grade from the one below.
When resubmitting a graded Pokémon card makes sense
Have a specific, checkable reason, not a feeling:
- You can't find the flaw. Under a loupe and bright light, the centering, corners, edges and surface all look perfect, and you can't say why it isn't a 10.
- It was graded long ago. Standards and holders have changed over the years. An old slab may not reflect how the card would be judged today, though this can cut both ways.
- The label matters for this card. Some buyers prefer one company's slab for a given card; our PSA vs CGC vs BGS guide covers which label carries a premium and when.
When to leave the slab alone
- You can see the flaw. If you can name what held it back, the next grader will see it too.
- The card is cheap. If the grading fee and shipping are a big share of what the card is worth, the question answers itself.
- The card is fragile. Old holos scratch easily, and every time a card leaves its case it can pick up a mark.
- The case is the only problem. A scratched or yellowed holder can be replaced without regrading (see below).
How to crack a PSA or CGC slab safely
If you do crack a slab, the card is most at risk in the first minute.
- Photograph the slab and label front and back, so you have a record of the grade and cert number.
- Wear eye protection and work over a soft cloth. Slab plastic can snap and fly.
- Work from a corner, away from the card. Use a slab-cracking tool or pliers to snap the corners and edges of the case, never prying near the card itself.
- Lift the card out slowly, still in its inner sleeve if it has one, and put it straight into a new penny sleeve and card saver.
- Check it for any new mark before you ship it, and pack it properly: see how to ship Pokémon cards safely.
A slab that has been opened can never be closed again, and a resealed slab is a red flag to buyers: see how to spot a fake PSA, BGS or CGC slab.
Reholdering a scratched or old slab
If the card is fine and only the case is scratched, cracked or old, a reholder puts the card in a fresh slab without changing the grade. Ask the grading company for its reholder service rather than cracking the case yourself, since a card you crack is raw and has to be graded again from scratch.
Before you crack a slab
- Check for an in-holder option first, such as PSA's crossover with a minimum grade.
- Name the reason the grade should be higher. If you can't, leave it.
- Look up the card's gem rate. A vintage card that rarely gets a 10 is unlikely to get one on a second try.
- Count the fees and the time away against what the card is worth.
- Crack carefully from the corners, and sleeve the card at once.
We don't grade cards, crack slabs, or take a cut of any grading company. We publish prices and population counts, both synced daily; the decision and the fee are yours. Not financial advice — just the numbers.
FAQ
What does it mean to crack a slab?
Breaking open a graded card's sealed case to take the card out. The card becomes raw again and loses the slab's protection and authentication until it's graded again.
Is it worth cracking a slab to regrade a Pokémon card?
Only when you can name a specific reason the grade should be higher and the card is worth far more than the fee. Most slabs are graded correctly, so most resubmissions come back with the same grade or a lower one.
Do I have to crack a CGC slab to cross it over to PSA?
Not for PSA's crossover service. PSA grades the card inside its current holder and only removes it if it meets the minimum grade you put on the form; otherwise it comes back in the original case.
How do you crack a slab without damaging the card?
Photograph it first, wear eye protection, and snap the case at the corners and edges with a cracking tool or pliers, away from the card. Lift the card out slowly and sleeve it straight away.
What is a reholder?
A fresh case for a card that's already graded by the same company, at the same grade. It's the option to use when only the slab, not the card, is the problem.
